EZconnex® 3-port Float Switch Connection System

• (3) Quick release float connection ports
• A single 6 conductor direct burial cable with shield
• Housing is imprinted with R-B-Y that matches Red-Blue-Yellow cable wire pairs for easy float identification
• Rated for short term water submersion
• Includes mounting bracket with hardware
• Designed for use with EZconnex® float switches (not included with manifold; float switches must be ordered separately):
  • Low current applications down to 0.160 mA at 125V
  • Mechanically-activated, snap action contacts
  • Quick release float connection simply plugs into manifold port(s)
  • Colored caps for easy identification of Normally Open (blue cap) or Normally Closed (red cap) models
  • Activation angle above/below horizontal:
  • 4″ (10.16 cm) wide-angle; 1.5″ (3.81 cm) narrow-angle
  • Each float switch includes a protective rubber boot that provides a dual seal design for an extra layer of protection to keep connections clean and dry

Manifold Options:

• Standard cable lengths of 25, 50, or 100 ft (7.62, 15.24, or 30.48 m).
• Sealing plug (includes rubber boot) required for unused port(s).

Float Switch Options:

• Standard cable lengths of 5, 10, or 20 ft (1.52, 3.05, or 6.10 m).
• Blue cap for normally open (high level) applications or red cap for normally closed (low level) applications.
• With narrow or wide-angle pumping ranges.
• Two float mounting configurations available:
  • Mounting Clamp: for applications where the switch can be attached
    to a float tree or similar mounting device.
  • Cable Weight: includes clip-on cable weight; floats should be hung
    from a hanger bracket (ordered separately)

CSA Certified

Five-year limited warranty